Auto repair & tire shop
Services
New and used tires, brakes, A/C, state inspections and engine work on Josey Lane, right under the LBJ. Exotics, work trucks and daily drivers all get the same bay and the same standard.
-
Tires & wheels
New and used tires, mounting and balancing. Work-truck sets through staggered fitments on something quicker.
Typically includes
- Mount and computer balance
- New valve stems or TPMS service kit
- Torque to factory spec
- Old tire disposal
- Pressure set and road test
-
Brakes & safety
Pads, rotors, calipers and fluid. Inspected and quoted before anything comes apart.
Typically includes
- Pads and rotors, front or rear
- Hardware, shims and clips
- Caliper slides cleaned and lubricated
- Brake fluid level and condition check
- Road test and bed-in
-
State inspection
Official Texas inspection while you wait. If it fails, we repair it here and re-run it.
Typically includes
- OBD emissions scan
- Brakes, steering and suspension
- Lights, horn, wipers and mirrors
- Tires and tread depth
- Windows, seat belts and exhaust
-
Engine repair
Timing, gaskets, mounts and internal work. The jobs a quick-lube turns away.
Typically includes
- Diagnosis before any teardown
- Gaskets, seals and hardware replaced
- Fluids refilled to spec
- Post-repair scan and road test
-
Engine diagnostics
Check-engine scans and drivability troubleshooting on the actual cause, not a guess at parts.
Typically includes
- Full OBD scan, stored and pending codes
- Live data under load
- Visual inspection of the affected system
- Written findings before work is quoted
-
Transmission
Flush and fluid service, diagnosis and repair on most makes.
Typically includes
- Fluid and filter service
- Pan gasket replaced
- Scan for transmission codes
- Level set at operating temperature
-
Suspension, shocks & struts
Struts, shocks, control arms, tie rods and ride-quality diagnosis.
Typically includes
- Struts, shocks or coilovers
- Mounts, bearings and boots
- Torque to spec at ride height
- Alignment recommendation after install
-
A/C & heating
Recharge, leak diagnosis and component replacement — worth doing before a Texas August.
Typically includes
- Performance test, vent temperature measured
- Leak check with dye or electronic detector
- System evacuated and recharged
- Refrigerant oil and dryer as needed
-
Radiator & cooling
Radiator flush, water pumps, thermostats and hoses. Overheating is the expensive one.
Typically includes
- Coolant drain and flush
- System pressure and cap test
- Thermostat, hoses and clamps as needed
- Bleed and heat-cycle check
-
Electrical & starting
Batteries, starters, alternators, sensors and wiring faults.
Typically includes
- Battery load and charging system test
- Starter draw test
- Terminals cleaned, cables checked
- Alternator output under load
-
Exhaust & emissions
Exhaust repair and emissions troubleshooting ahead of inspection.
Typically includes
- Leak inspection, manifold to tip
- Gaskets, clamps and hangers
- Oxygen sensor testing
- Emissions readiness verified
-
Oil & fluid service
Valvoline conventional through full synthetic, filters and fluids on schedule.
Typically includes
- Oil and filter, spec grade
- Drain plug gasket replaced
- All fluids topped off
- Tire pressures set
- Used oil disposal
-
Tune-ups
Plugs, coils, filters and the maintenance that keeps a small problem from becoming an engine.
Typically includes
- Spark plugs to factory gap
- Coils, wires or boots as needed
- Engine and cabin air filters
- Throttle body cleaned
- Post-service scan
-
All welcome
Exotics & performance
Lamborghini, Mercedes, Corvette, lifted trucks and classics. Same care, no dealer markup, no attitude about what you drive.
Typically includes
- OEM or OE-equivalent parts sourced
- Torque to manufacturer figures
- Wheel and finish protection during service
- Same process, no dealer markup
Not sure what you need?
Call and describe what the vehicle is doing. We'll tell you what it likely needs before we come out.