Farmers Branch One Stop Shop for all Automotive Needs.

• Tires & wheels

  New and used tires, mounting and balancing. Work-truck sets through staggered fitments on something quicker.

  Typically includes

  • Mount and computer balance
  • New valve stems or TPMS service kit
  • Torque to factory spec
  • Old tire disposal
  • Pressure set and road test

• Brakes & safety

  Pads, rotors, calipers and fluid. Inspected and quoted before anything comes apart.

  Typically includes

  • Pads and rotors, front or rear
  • Hardware, shims and clips
  • Caliper slides cleaned and lubricated
  • Brake fluid level and condition check
  • Road test and bed-in

• State inspection

  Official Texas inspection while you wait. If it fails, we repair it here and re-run it.

  Typically includes

  • OBD emissions scan
  • Brakes, steering and suspension
  • Lights, horn, wipers and mirrors
  • Tires and tread depth
  • Windows, seat belts and exhaust

• Engine repair

  Timing, gaskets, mounts and internal work. The jobs a quick-lube turns away.

  Typically includes

  • Diagnosis before any teardown
  • Gaskets, seals and hardware replaced
  • Fluids refilled to spec
  • Post-repair scan and road test

• Engine diagnostics

  Check-engine scans and drivability troubleshooting on the actual cause, not a guess at parts.

  Typically includes

  • Full OBD scan, stored and pending codes
  • Live data under load
  • Visual inspection of the affected system
  • Written findings before work is quoted

• Transmission

  Flush and fluid service, diagnosis and repair on most makes.

  Typically includes

  • Fluid and filter service
  • Pan gasket replaced
  • Scan for transmission codes
  • Level set at operating temperature

• Suspension, shocks & struts

  Struts, shocks, control arms, tie rods and ride-quality diagnosis.

  Typically includes

  • Struts, shocks or coilovers
  • Mounts, bearings and boots
  • Torque to spec at ride height
  • Alignment recommendation after install

• A/C & heating

  Recharge, leak diagnosis and component replacement — worth doing before a Texas August.

  Typically includes

  • Performance test, vent temperature measured
  • Leak check with dye or electronic detector
  • System evacuated and recharged
  • Refrigerant oil and dryer as needed

• Radiator & cooling

  Radiator flush, water pumps, thermostats and hoses. Overheating is the expensive one.

  Typically includes

  • Coolant drain and flush
  • System pressure and cap test
  • Thermostat, hoses and clamps as needed
  • Bleed and heat-cycle check

• Electrical & starting

  Batteries, starters, alternators, sensors and wiring faults.

  Typically includes

  • Battery load and charging system test
  • Starter draw test
  • Terminals cleaned, cables checked
  • Alternator output under load

• Exhaust & emissions

  Exhaust repair and emissions troubleshooting ahead of inspection.

  Typically includes

  • Leak inspection, manifold to tip
  • Gaskets, clamps and hangers
  • Oxygen sensor testing
  • Emissions readiness verified

• Oil & fluid service

  Valvoline conventional through full synthetic, filters and fluids on schedule.

  Typically includes

  • Oil and filter, spec grade
  • Drain plug gasket replaced
  • All fluids topped off
  • Tire pressures set
  • Used oil disposal

• Tune-ups

  Plugs, coils, filters and the maintenance that keeps a small problem from becoming an engine.

  Typically includes

  • Spark plugs to factory gap
  • Coils, wires or boots as needed
  • Engine and cabin air filters
  • Throttle body cleaned
  • Post-service scan
• All welcome

  Exotics & performance

  Lamborghini, Mercedes, Corvette, lifted trucks and classics. Same care, no dealer markup, no attitude about what you drive.

  Typically includes

  • OEM or OE-equivalent parts sourced
  • Torque to manufacturer figures
  • Wheel and finish protection during service
  • Same process, no dealer markup

Full service list